Interested to Buy Any Domain ? << Click Here >> for more details...
what is the formula for converting KW into KWH ?
- 3 Answers
- 7890 Views
- Blue Star, Essar, I also Faced
- E-Mail Answers
Answer Posted / guest
just calculate the KW and multiply with running hours.you
will easily get KWH.
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
What is the Surge suppresor? Why using in a UDB's and How it works?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
why we are not giving the zone 1 trip command to the master trip relay
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what is the difference between electrical and electronic choke?
define hysteresis loss, eddy current loss and windage loss
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
what are carbondioxide and dcp used in fire extinguishers
State nyquist stability criterion.
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
can any tell me why slope 40% and 80% is calculated in differential protection?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
