If the capacitor feeder is switched ON without any load, is there any display in the ammeter at the incomer?
- 3 Answers
- 5096 Views
- RTD, Welspun, I also Faced
- E-Mail Answers
Answer Posted / karthik_elec
yes the ammeter will show some small current value, if the
capacitor fully charged it will not take any current
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
write a program that prints prime numbers from 1-20 in digonal form
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
How CFL &T5 tube light glows?
State The Difference Between Generator And Alternator?
plz tell me,ht and lt panel terminals in substations explain beiefly
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
When steam condenses and becomes water at the same temperature, the specific heat for the process in kJ/kg k is
how to calculate compresor capacity?
Draw a block diagramof Three UPS systems connected in Parallel mode?
what is EIB lighting control system? what is the advantages of this system?
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
determine two methods to find loose connection in operational electrical system?
What is the Surge suppresor? Why using in a UDB's and How it works?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
What are the operation carried out in thermal power station?
