Interested to Buy Any Domain ? << Click Here >> for more details...
what is earthing ,grounding in c&i panel?what is the
resistance in earthing and grounding of c&i panel?what do u
mean by shielding and what is its resistance?
- 1 Answers
- 11077 Views
- I also Faced
- E-Mail Answers
Answer Posted / siddhartha jyotishi
resistance should not be more than 2.5 ohms.
shielding resistance is 2Mohm.
| Is This Answer Correct ? | 6 Yes | 7 No |
Post New Answer View All Answers
What are the uses of orifice plates?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
the 3 most common transmitter protocol being in refinery or qatar gas and aramco.
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
Explain PID controller tuning & any one method used for it.
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
Tell me the field calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter.
describe flow nozzel principle?
In turbine what does term CDP, NI, NH, HSSOC means.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
I need to know steps to Calibration Valve Guard......
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
