we can stepdown the voltage from 230/12v ,and we use the
voltage for various electronics components why can't we
step up the voltage from 12/230v if we can shall we use the
voltage for domestic single phase supply
- 5 Answers
- 7746 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / raj
it is not possible, because like ashish said, it wont
withstand insulation part ,gets oveheated and rbursted,
for each trans former insulation is also a mater with
depends on load and area its gona to use...
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the BS(British Standard)code for 11kv motor
is it possible to start a motor in felid connected to a remote mcc
how is control wiring coding is done in a CRP panel ?
I WANT TO INSTALL LIGHTING ARRESTOR ABOVE 20 FEET HEIGHT INDUSTRIAL BUILDING. NOW IT WAS 15 FEET HEIGHT HOW MUCH DISTANCE IT WILL COVER & HOW TO CALCULAT THE DISTANCE COVER BY THE ARRESTOR
How does the phase sequence controller works, how it identifies the phases? confirm working principle
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
Circuit diagram of tube light without starter using electrical choke
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?
what is the difference between oil surge relay and buchholz relay.
how to changeover ups in this power failur time?
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
