Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tapasi
wave trap is a instrument used in substations to eleminate
the communication & unwanted waves tranported with the
current. it is generally connected with y & r phase because
the substations r communicate with each other through these
lines.
| Is This Answer Correct ? | 6 Yes | 14 No |
Post New Answer View All Answers
Why front mounted CT polarities are always towards breaker?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
is there any current and voltage drop on liquid resistance starter water/soda tank ?
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
Mention the disadvantages of low power factor? How can it be improved?
why we change the direction of winding in rotor ?how we make the north and south pole?
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
How we calculate the current carrying capacity of H.T. cabel?
