Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / masoom raza
simple in transformer two winding are not connected electrically(they are linked magneticlly) so we
cannot apply apply ohm law between primary and
secondary. but you can apply it to individually
in primary and secondary side.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Define sensitivity?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
How grounding is different than earthings?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
In what condition the HT fuse breakes?
What do you mean by an instrument transformer?
Discuss about gear cutting machines.
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
What is meant by harmonic distortion?
Why the magneti fields are not passes from southpole to north pole
what is 400kv doble circuit quadpole tower?
Single line digram for 11 kV to distribution use go,la and do
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
