Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the rating of ELCB OR RCCB for an
equipment?
- 2 Answers
- 24058 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
what is the max. acceptable leakage current in 33kv bus bar
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
Why the power factor improvement is so important in industrial loads
What is the use for cable entry in control room?
can we synchronize star system generators with delta system transmission line ? and how ?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
what is the calculation formula for motor starting torque,running torque, running torque.
what is the main function of capacitors in mccs.
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
When we need up only in o/p 440v, so why we use directly in 11kva in input?
