Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / varun
defined in steps as under:
1. Calculate load current
2. multiply this current( take some higher value) with 1.1
0r 1.2 acc. to derating factor
3. calculate length of cable to be used
4.see cable catalogue and calculate voltage drop in cable
which should be less then 6%
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How we calculate the size of ht cable for any transformer
How to calculat the ratio of HT\LT in energy meter
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
In dc ckt. 24v or 110v, which one is more efficient and why?
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
Mention the difference between Analogue and Digital circuit?
How to design the NGR Resistance
The windings of a transformer are divided into several coils, because?
As i want some model question paper in basic computer science and history please send me immediately sir
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
what is the safety points of vaccum circuit breaker.
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
