Interested to Buy Any Domain ? << Click Here >> for more details...
from which formula we select a capacitor rating?
- 4 Answers
- 9357 Views
- Suzlon, I also Faced
- E-Mail Answers
Answer Posted / dhinakaran.s
capacitance is the ability of a body to hold an electrical
charge. Capacitance is also a measure of the amount of
electrical energy stored (or separated) for a given
electric potential.
Capacitance is given by C = Q/V farad.
The SI unit of capacitance is the farad; 1 farad is 1
coulomb per volt.
In parallel plate capacitor,
C=εA/d farad.
where
ε=ε0*εr
C is the capacitance;
A is the area of overlap of the two plates;
εr is the relative static permittivity (sometimes called
the dielectric constant) of the material between the plates
(for a vacuum, εr = 1);
ε0 is the electric constant (ε0 ≈ 8.854×10−12 F m–1); and
d is the separation between the plates.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
What is the size of a 60 watt and 80 watt tubelight?
How to calulate Locked rotor amper(LRA) for compressor type motors?
1.Z transform always lies around ? a) origin b) pole c) zero d) z=1. Multiples Mcqs which is bother me can’t find answers on internet. Some help required with little explanation . Note: this is not homework or related to any test. Thanks
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
Earth leakage relay basic knowledge principle
Why lose 1 phase voltage in 33kv to 415v stepdown transformer
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
defination of lines
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
Define characteristics impedance?
