Answer Posted / grv
Productivity is defined as ration of output to input but it is measured by three points...
1. getting more output from fixed input
2. getting same output but input should be reduced continuously
3. getting more output with more input but increase in output must be more than increase in input
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what does EN230 material mean?
Can any One Help me to Know about Fire hydrant and its related water Pressures
state the care that shall be taken while checking the diode
how could you change gas line control valve to liquid line valve?
What is difference between npn & pnp sensors?
what casues little rust pockets to pop through or off concrete cylinder blocks (home)?
I have problem in APFC panel -0.44 while load ON time, i have replaced APFC display & checked the CT supply are ok. how to solve the problem
Mention different type of processes?
what is alternater & engine genral protection?
where is fixed bearing located?
I have 200kg weight cylinder,I want to rotate,but i don't know what is torque of cylinder and what's size of motor for rotate the cylinder.i want to know calculations find out torque of cylinder.
how do you check pump impeller front clearance?
Share with us about a time when you had to present a proposal to a person of higher position and were able to do it successfully?
What is quality management system? Weather qms is suitable, adequate and effective or not? Is there any quality policy? Is there any quality objective? If yes, then what are they? How they are planning to achieve quality objectives? Do they are measure quality objectives?
On what bases time study methods can be calculated?