Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
Switching station is tapping point with' LiLo' configuration
for tapping the line for a spur line ,usually for evacuation
from a generating station
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why the neutral point in connnection oscillates?
what is the difference between electrical choke and electronic choke?
why does connected a indutor with mnsformeretering core of current transformer ?
What do you mean by Frame 5 Gas Turbine as well as Mark II.
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
How to select circuit breakers rating eg. if i select a circuit breakers of capacity 40 amps DC with operating voltage 28 volts and if i what to use same circuit breakers for 300 Volts DC application what is the current rating of this circuit breakers.
Why an ac systems are preferred over dc systems?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
what material is the electrical housing wire made of? is there any difference for the telephone lines?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
Why compensation is necessary in feedback control system?
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
