Interested to Buy Any Domain ? << Click Here >> for more details...
what will be happen if we apply D.C supply to the
transformer
- 14 Answers
- 23584 Views
- CCBPL, I also Faced
- E-Mail Answers
Answer Posted / ashish chourasia
According to Volt-Amps balance, B is directly proportional to integeration of the voltage wrt time. Therefore for a D.C. supply the it will be tremondously increasing and will burn the insulation due to absence of back emf and the transformer will damaged due to intense heating.....
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
where solid grounding and where grounding through ngr done and why?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
What is an Air COmpressor
why we used dc supply for field in dg set
What is the two pole structure?
can any one know is sbi interview based on merit or based on roll number
WHAT IS LOAD CELL
checking procedure of capacitor based motors.used in fans etc?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
what is solkor relay and which condition it will act?
Why lose 1 phase voltage in 33kv to 415v stepdown transformer
Name one of major transformer company in KSA ?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
