Interested to Buy Any Domain ? << Click Here >> for more details...
In Boiler Drum Level- Level control valve how can it tuning
(PID)?
- 2 Answers
- 8027 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashok prajapat
first of all it is important that how much level u want to
control in boiler for exp. if u want to set level 50 % in
boiler then first of all set only p value n pid controller and
this time keep i and d at zero and see process value.now slowly
increasethe value of I and then see again process value and
finally set d value if required.for exp range of these values
may be;
P: 0-100
I: 0-20000
D: 0-100
ASHOK PRAJAPAT
(INSTRUMENTATION ENGINEER)
prajapat.ashok@yahoo.com
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
What is the working principle of the magnetic meter?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
principle of automatic votage regulator
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
what is performance test.need defination
How to calibrate Toxic gas detector?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
In turbine, what does term CDP, NI, NH, HSSOC, means
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
What is furnace draft control?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
How many types of sensor
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
