Interested to Buy Any Domain ? << Click Here >> for more details...
We are using 3core 11KV HT cable for same phase for
generator outgoing, the cable leakage current is high and
cable heated overly what is the remidy, if we use the 3core
cable for 3phases the problem is solved are not?
- 1 Answers
- 4279 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If earthing for pot heads is done at the both ends remove
one of them and watch.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1.what is the reason for transformer and lightning arrester blast in 33kv system
What do you understand by oldham's coupling ?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
Define availability (operational)?
what is the difference between earthing and unearth
in shunt clippers why a resistor is used in sereis with the input
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
How to use earthing on shipments.
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
can the measured percentage error during calibration of single phase energy meter be negative?
does any one know where we can purchase insulation oil for high voltage oil filled cables
Electrical Engineering
Differentiate between digital phase converter and ordinary phase converter.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
why swityard is necessrry requirement in any bis power distributin systems?
