why metallic housing is provided of solenoid valve.
- 1 Answers
- 4962 Views
- HPCL, I also Faced
- E-Mail Answers
Answer Posted / sreekanth
when solenoid is in on state,it dissipates heat.hence in
order to remove this heat metallic housing is required by
radaition/conduction
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Question on maha cement
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
Explain the difference between mmwc and mmwg?
What is ultrasonic flowmeter?
how to calculate the total flow in square root
kindly sent some demo question and answer
please tel me the calibration of pneumatic controler.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
What is offset in a control system.
NSV type probe stands for
What is difference between differential pressure & delta pressure?
what is wave length were using ?
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
