Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / deadzg_devil
Because in power stations large current flows thru the
cables n for measurement of currents or any fault the
apparatus required must be highly rated n it wud be costly.
Therefore PT's are used to step down the current to lower
levels for measuring them
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
what is the purpose of high speed earth switch in gas insulated substat
How to calculat the ratio of HT\LT in energy meter
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
explain wiring system
How to Calculate the Fault Level of Electrical Installation
could you measure current in parallel?
Draw the equivalent circuit of crystal oscillator?
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
Electrical Engineering
how many current required for hypo test
