if u want to buy a motor than what will be the
configuration of that motor?
- 2 Answers
- 3611 Views
- I also Faced
- E-Mail Answers
Answer Posted / sushant
1st ac/ dc motor n type of motor acc. to requirement like
induction motor. for ac if 3 phase or 1-phase
then kw rating, pf and speed(rpm).
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
What is the purpose of using busbar mounting fuse?
when will be the iocl interview results ifaced the interview on september 8 th
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
How to calculate Temp from Resister from PT100 equation,
What are the advantages of instrument transformer?
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
What is vacuum circuit breaker.define with cause and where be use it device?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
How to synchronization will be done between two DGs ?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
how to calculate singlephase motor efficiency?
How does PLC work for sychronising of Two or more DG sets?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
