Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between Split ring and slip ring?
- 8 Answers
- 37303 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul
split ring is use in dc motor to make the direction of
current uniformly . the rotor of generator rotate by 360
degree . as per principle generating wave be sinusoidal for
180 degree +ve & 180-360 degree -ve .so to make the
direction of waveform unidirectional the split ring rotate
after each interval of 180 degree .
the difference between slip ring & split ring is slip ring
are stationary . & split ring rotate after 180 degree
| Is This Answer Correct ? | 24 Yes | 10 No |
Post New Answer View All Answers
What will be the current if the resistance total in a series circuit doubles?
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
what is the Transformer Impedence?How can calculate?
What is rotating magnetic field?Discuss elaborately.
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
what is the id1 & id2 setting in differential protection relay of CSPC?
cc of scorpio?
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
