Interested to Buy Any Domain ? << Click Here >> for more details...
how is reactive power controlled on the transmission system
- 2 Answers
- 4555 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinod
In transmission system total reactive power is known and
distributed to different generating station(by excitation
different station feed their reactive power. But their is a
limit for max. reactive load from a generator. In the case
of additional requirement capacitor bank serve the purpose)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calculate the lightning arrester conductor @ no of earth pits required
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
HOW TO CALCULATE HV CABLE SIZING?
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
What is gross error?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
how many electricity poles are there and what are the names and their sizes.
Explain about p.t?
Why 1/3 is used in symmetrical components?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
what are the protecyion of transformer & generators
