Interested to Buy Any Domain ? << Click Here >> for more details...
How do we MEASURE OR CALCULATE VELOCITY used to calculate
REYNOLDS NUMBER??
- 3 Answers
- 8959 Views
- I also Faced
- E-Mail Answers
Answer Posted / jothi
In addition to the above,
Laminar flow shows a parabolic flow while a Turbulent flow
shows an irregular flow. This can be seen when you put a
piece of floating material like paper, small wood etc on
the flowing liquid.
But for Transient or the Partial flow, its normally based
on the assumptions, even if we know the Reynolds number,
which includes the type of Liquid, its viscosity, and
impurities too.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
what is the importance of CV in the control valves? how it is calculated?
why fuse block is not used for AI signal?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
What is wet leg condition and why is it used?
What is the diffrence between ff tx and non ff tx
Draw symbols of the following :
what is The specifications for oriface instalation
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
what is your eligibility criteria for freashers?
What is heating effect?
Operational amplifiers
send me last 5 years questions asked in rrb chennai, for section engineer
What are the interlocks we have to check during the start up of LP/HP compressor?
How the warning lamp of a charging-system is activated ?
