Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / brajesh kaurav
as per IS 456-2000(for concret structure)code minimum
laplength should be consider is 36d very d is greter dia.of
bar.and also laps will always be Staggered in
height/placement so to say all lapses will not be at one
position/placement.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How can we make a hole in a solid rectangle using solidsworks?
how much brick, cement, and sand required in 1mtr X 0.23mtr X 1mtr brickwork(1:4), 230mm thick wall and 10mm thick mortar , brick size 230mm X 70mm X 110mm
Define graphics window?
How to calculate thickness of MAT slab & Reinforcement? The dimention of under ground water reservoir is 80'X14'X 12 ft
punj loyed and sapurjl palanjl
What are some structures that may be subjected to fatigue?
Sir, Iam Applied in rrb for the posts of Junior Engineer.I want to know about the or question previews to study well.Pl send it to shukla_varun1985@yahoo.com.
estimate quanitity of bricks(19x9x9cm without mortar), cement & sand in 10feet X 10feet wall ?
All aptitude question of Bechtel
How many cum of 9.5mm stone in 1 ton ?
Any strength is a stress but any stress is not strength
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
Explain what is zoning permit?
What is the use of water table & Kreb stone for drain
What is the ideal size of the living room ranges from small to large size?
