Interested to Buy Any Domain ? << Click Here >> for more details...
WHICH INSTRUMENT USED TO CALIBRATE CONTROL VALVE?
- 23 Answers
- 54270 Views
- Exxon Mobil, Honeywell, I also Faced
- E-Mail Answers
Answer Posted / mat
This is control valve calibration not transmitter, for control vale calibration we have to used pneumatic source from this source we can give pressure from 3psi to 15 psi.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
whats the abbreviation of IOP? is it instrument of power or input open problem?
If fire would be inside the plant which fire detector is to detected the fire.
what can of fault ofently come in vibration mesurement?
types of cable..? Use of every types of cable..?
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
What is the use of control cable?
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
what is the difference between magnetic flow meter and mass flowmeter
Explain an adaptive / self-tuning controller’s major draw card.
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How digital input and digital output 's are working in dcs
Explain the combusion chamber
