Water is available at 10m height. What is the pressure available ?
- 6 Answers
- 10879 Views
- Bhel, TVS, I also Faced
- E-Mail Answers
Answer Posted / deepak
981000
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How to calibrate Vacuum Gauges if you don't have any standard gauge available with you? please suggest procedures for calibration of Vacuum gauge like pirani gauge ,cold cathod gauge,thermocouple gauge without any standard gauge.
One litre is equal to ________cm3 ?
can anybody provide me the HPCL apptitude papers?am having the test on this feb 19th 2008 so plz
Define a uniformly distributed load.
What is the name given to ratio of actual cycle efficiency and ideal cycle efficiency?
during the design of a friction clutch what are the considerations that should be made?
where can i get railway junior engineer(mechanical) previous years question papers?
Horse power of i.c. Engines can be expressed as rac rating, sae rating, or din rating. To which countries these standards belong ?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What do you understand by catenary cable ?
What are the different types of bearings?
Hello sir! I hav read the above discussions about PSU.I hav 72% aggregate in Mechanical bt i do had a back in 1 subject,so m i too eligible for PSU?
DIFFERENCE BETWEEN CODES,STANDARDS & SPECIFIFCATIONS?
What are the advantages of dtsi over normal engines?
How does a modern submarine move?
