Interested to Buy Any Domain ? << Click Here >> for more details...
1.two coupled coils with L1=L2=0.6 H have a coupling
coefficient of k=0.8 the turns ratio N1/N2 is......
- 5 Answers
- 32586 Views
- BSNL, SSC, I also Faced
- E-Mail Answers
Answer Posted / vinova
well frnd it cant be calculated as you can calculate mutual
inductance M = K*underoot(L1*L2)
Further M=(N1*N2)/S (s is reluctance)so the data in the
above question is insufficent to calculate N1 and N2. if it
is asssumed that both have same length l and both carry
same current and both have equal magnatic field intensity H
then it can be said that N1 and N2 are equal as H*l = N*I
here l s the length of conductor
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
what is the difference between vector scale and vector diagram?
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
what is meant by 2 within a star in a voltmeter dial?
What is the RME and explain the full form and what is the RME work?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
what is the difference between gas group b and gas group c electrical equipment construction wise?
What determines the thickness of the lamination or stamping?
What is the need for a controller?
Can anyone tell the proper diagram of star delta starter????
Difference between earthing & grounding.?
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
Which capacitor is preferred for high voltage and frequency?
