Why not LED burn after showing alarm,as Alarm volt is 11-
13,But LED is of3 volt,why it isnt Burn??
Answer Posted / pillay
You are right but the voltage to the LED is reduced by
connecting a resistor in series or a few LED are connected
in series so the voltage across each LED IS about the rated
voltage.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Alternator rotor earth fault relay circuit
what is motor capacity of 80TR chiller? and also say what is the formula related temperature, motor capacity, TR?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
what is the difference between torque induced and torque load?compare them with respect to dc motor?
What is mason's gain formula?
What is nyquist contour?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
iam working in power plant. In hot places tube lights are glowing at the end portion only. what is the reason for that?
what is your majour contributions in your present job
What safety precaution are to be taken for avoiding electric hazards ?
STATE USE OF ARC RUNNERS & SPLITTERS ?