Does switch has the IP Address. If YES? How to find it?
- 7 Answers
- 9708 Views
- Wipro, I also Faced
- E-Mail Answers
Answer Posted / mohit s
SW can be assigned an IP address, By default no IP is
assigned to it. You have to go into the interface VLAN 1 and
the have to put the ip address and subnet..
And Layer 3 Sw can also act as router and you can assign the
IP to the interface by putting below commands
switch(config)#interface fa0/0
switch(config-if)#no switch-port
switch(config_if)#ip address x.x.x.x
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Name the vtp modes?
Explain what is the default behavior of access-list?
What are the ranges of private ips?
What does the meaning of
Mention what is the difference between tcp and udp?
How is private ip different from public ip?
Explain why is udp lease favored when compared to tcp?
Which layer called error detection layer?
Explain what is overlaod?
Which 2 protocols are in wan technology?
What is default time of hello packets in ospf?
What we called 64 bit mac-address in ipv6?
Define the igp (interior gateway protocol)?
Why is network segmentation a good idea when managing a large network?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
