Interested to Buy Any Domain ? << Click Here >> for more details...
How much allowable difference current between on three
phases
Dear sir,
We have a 1870 KW HT motor, 11 Kv supply,FLA-120A,2870
rpm,2-pole squirrel cage induction Motor.And stator is
connected in star connection with Liquid resistance stater
to limit the starting current.It has coupled with
Centrifugal air compressor.My question is it is loading 73%
of FLA taking R-phase 86.7 A, Y-phase-85.4A,B-phase-
78.3A.why the B phase current is that much of difference.Is
it allowable, or any one tell me how much allowable
current.If any method to calculate.
- 1 Answers
- 5830 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Change the phase sequence from RYB to YBR and BRY and
analyze the results
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
how mass curve differs from hydrograph.
how r charge carriers produced
what is meant by skew width in machines?
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
Comment on the working principle of operation of a single-phase transformer.
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
List the characteristics of filter?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
At full load wat is the motor p.f And at no load will is the motor p.f?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
Can any body tell me the different types of LT cables & their application.
How to select a transformer group to connect a 0,433 KV generation with 33 KV grid in bi directional flow of current
