Interested to Buy Any Domain ? << Click Here >> for more details...
In 110V DC supply,if a closed circuit gets open, How can we
identify the voltage which is measured after the
resistor(4KOhm) which is open with negative.it shows 55V +ve
when measured, also the actual positive source is 55V +ve
.Because there is no voltage drop in open circuit. How can
we identify whether this is the voltage which is series with
the resistor or the DC source direct +ve.
- 1 Answers
- 4439 Views
- GE, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Apply a load and measure voltage
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
WHAT IS THE TECHNICAL SPECIFICATION OF C CURVE & D CURVE LEGRAND MAKE MCB
How you calculating the 30 Hp 3 phase AC motor of power what size of cable is used for this motor?
What is the magnetic field (coil DC ) of Turbo Expander?
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
How to calculate or formula to calculate rhe power in 2 phase system ??
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
Determine the BTU size of an aircon for 20 sq metre room
what are the principles of a booster converter?
how dose servo motor works
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
In siemens PLC, why do we want to move the data ?
i karmveer bharti persuing b.tech . plz send me syllabus and name of reference books. for preparation of section eng.
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
