Interested to Buy Any Domain ? << Click Here >> for more details...
What is the reason for not giving very High Proportional
Gain Kp in PID Controller?
- 2 Answers
- 7825 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / www.islamqa.com
Great answer Deepti
and also with increasing the Kp gain we increase the MAX.
OVEERSHOOT of the process which may harm the process and
lead to unwanted consequences.
Regards,
Ahmed Sabry
Control and Instrumentation Engineer
GPC - General Petroleum Company
ahmedsabry.online@gmail.com
CELL.: 00 2 0121367310
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
what is interlock system and why we use of this?
What do you know about gail?
We are using Rosemount 5400 series Radar Level Transmitters in all types of Sump Applications having oily water hdrocarbon petrochemical nature. What we are facing the problem frequently is that always getting reading frezzed at some value. If we do power recycling , sometimes it is working . then making same freezing problem. If anybody faced before such type of problem and also having solution , Please give the answer.
why Fahrenheit unit of moistur analyzer transmitter
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Difference between ultra sonic flow meter
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
full process of gas turbin?
give eg of how I/P is used in control loops
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
How do bending tubing provide better measurement than using tubing fittings such as elbows?
how to calibrate 0- 150 psi presure gauge by dead weght tester
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
What is the diffrence between ff tx and non ff tx
