Answer Posted / paramesh
DC.... Because for AC having +ve and -ve half cycle.so if
any shock will occur means it will be suddenly released..
But in DC it has only +ve or -ve cycles.so it will not
released.... DC is Dangerous.....
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
How you will determine the volume of oil in a particular Distribution transformer.
define as synchronous generator
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....
what is the difference between "Rotary bypass isolation switch and Normal bypass switch" pls share indepth techs?
How good are you in resolving the commercial issues to Employer's advantage?
what is meant by neutral compensation factor and where it is used
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
How is the gain affected by the introduction of feedback in a control system.
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Why strting torqe high in inducation motor?
what is sevice settings for mccb?How can be it setted?
Can any body tell gulf interview question for experienced electrical engineer ?
What is the efficiency during maximum power transfer?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
