why rating of motor in HP ?

Answer Posted / jutt

tum chahe to litres me kar lo but usko methematical
expression se suppor karna hoga.

Is This Answer Correct ?    0 Yes 3 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable

1533


how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you

1514


A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?

682


please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula

1797


Which motor will you choose which can operate in both lagging as well as leading power factors?

658






Purpose of providing neutral isolation panel for parallel operation of diesel generator

1196


What are the effects of adding a zero to a system?

682


what is model question rrb junior engineer electrical gr.II

1553


What is the effect of positive feedback on the stability of the systems?

649


for 750 kw LT load what will be the ht kva

1251


. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?

2836


If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables

906


State the factors, for the choice of electrical system for an aero turbine.

672


does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain

1412


Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?

2486