how to given power supply of any type two wire transmitter
in field?
- 4 Answers
- 7681 Views
- Dr Reddys, I also Faced
- E-Mail Answers
Answer Posted / manoj kumar
A two wire transmitter is connected directly to the wires
coming from DCS/PLC with (+)ve to the (+)ve terminal of the
transmitter and (-)ve to the (-)ve terminal of the
transmitter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
what are the use of belew gear in general ??
How to calibrate Toxic gas detector?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
selection criteria of control valve? and selection criteria of actuator explain in brief?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
How to find out the current of two motors having same power consumption but different RPM?
how u calibrate pneumatic n motorized c/v?
what is wave length were using ?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
what is the working principal of pribe
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
where proximity sensor installed on tank in loading arm application
How to work temperature gauge?
if in a level tx height is given, how u calculate the ranges of the tx?
