Interested to Buy Any Domain ? << Click Here >> for more details...
How to run 1ph motor(230 VOLTS its full load amps
is 4.5 ampa))with 480 volts main(we didn hav
neutral)Thn we go for step down transformer.Our load 10
amps,so we conisder this amps in primary are secondary side?
- 1 Answers
- 3405 Views
- I also Faced
- E-Mail Answers
Answer Posted / parminder
YOU CAN STEP DOWN VOLTAGE TO 110 V THEN CAN RUN MOTOR ON TWO
PHASE.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
How to select, design,size & calculate for 11 KV/33KV/66KV/132KV/220 KV/440 KV circuit breaker for HT side of transformer protection/HT distribution protection?
How could a garment factory benefit from renewable energy
What is the effect of positive feedback on the stability of the systems?
How to Make relay co ordination chart for a Electrical power distribution of a plant
What kind of socket shall be provided for window type air conditioner with cooling capacity upto 18000 BTU/hr
Define average demand?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
how are reversing the direction of rotation of dc motor
Can we use Ccapacitive voltage transformer directly for metering purpose?
how rectifier transformer work in electroststic precipetatore(esp?
how to discharge 3 phase power factor correction capacitors
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
why power factor is important?
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
