i am going to attend ongc exam this coming june for
Graduate Engineer Trainee post
if anybody knows the question pattern or have experience
plz share it with me
Answer Posted / ram charan maurya
I have cleared ONGC exam in 2010. now i am working with
ONGC. pattern is like that total-120 questions objective
and 4 quetions subjective(2 technical of 5 marks each and
two non-technical current issu related questions of 5 marks
each). 80 questions from technical and 40 questions from
non technical GK .Technical questions comes from mainly
analog electronics(major portion), digital, control
system,microprocessor 8085 and little bit from
instrumenation(mainly from A.K.shahwany book).questions are
little difficult . subjective questions of technical are
very easy theoratical type.Non technical questions are
generaly from Current, history,Constitution.for it you can
lucent book or daily any patrika.
all the best
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
detail of mass flow meter pricipal
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
draw the block diagram of a level transmitter ?
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
I need to know steps to Calibration Valve Guard......
is motorized valve closed when power shutoff?
how to work static pressure sensore how to work dpt
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
How to interfacing microcontroller with a DC motor