Answer Posted / shaikh
if we consider a water pipeline system in analogy of
electrical system then the pressure ( force ) of water is
considered as a voltage and quantity of water can be taken
as current...
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
why voltage form factor of PT are increase , when it is ecpected heigher spikes in system. how it is calculated.
how to check three phase motor torque value?
What is difference between Harmonic and Non harmonic Capacitor Bank?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
What is gross error?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
I am going to appear for the RRB Chennai junior Engineer online exam. Please send me the previous exams question papers (also solved) to my mail id: rrkhandhar@yahoo.com
Why temperature rise is conducted in bus bars and isolators?
How are load losses and no-load losses measured at site in a DG set?
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
what is data block in plc ? How the values of data block are written and read by hmi ? what is the difference between function and function block ?
one conductor length is L.and i am strech uniformly this conductor and made length is 2L.so resistance of this strech conductor is R=4R..but i want to know about area of stech conductor hows it become a/2..
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
