Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vijay kumar
above ans is right but i want to add this at neturl point
current is zero & at earth point voltage is zero.....
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
How to convert milliampares into flow??
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
Why are the uses 24vdc in industries
what is wave length were using ?
How vortex sensor used for steam flow measurment can be checked on line i.e without taking out from process line.
What is the diffrence between ff tx and non ff tx
applications of plc in printing and packaging?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
