Answer Posted / mujahid khan
The symbol I was chosen for current because early
scientists were used to refer electric current as the
intensity of the electricity in a wire.
| Is This Answer Correct ? | 56 Yes | 9 No |
Post New Answer View All Answers
Explain using drawings what is reverse PID action w.r.t PID controllers.
What is gross error?
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
What OPGW is better than Microwave or PLCC???
If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What is industrial plc
I want definition for ABT Meter (Availability Based tariff) ?
State ohm’s law?
how cables go in and come out for distribution from the feeder pillar box?
What are gain margin and phase margin?
How to address the servo drive for motor
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
