what is formula in determining the size of Circuit Breaker
for transformer with the following specifications. 7 units
of 1600 volts (primary) and 400 volts (secondary). Both
Primary and Secondary will have a circuit breaker which is
SF6. What should be the Switchgear Main Breaker Size anf
the sizes of each brances Circuit Breaker for Primary.
- 1 Answers
- 4408 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
What is the expected max load?
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
why zero sequence impedance measurement is not applicable for single phase GT
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
What is genrally the % Impedance of a Dg set? How can we calculate Earthing conductor size for a DG set?
state types of reflectors in illumination engg. ???????
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
What is the effect of pi controller on the system performance?
Circuit diagram of tube light without starter using electrical choke
what parameters should we check to reduce the power bill
what is differant beetween overload current and phase current?
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
Phase control and integral control are used for?
