Interested to Buy Any Domain ? << Click Here >> for more details...
why we use primary delta connectin in hight voltage transformer
- 2 Answers
- 5301 Views
- I also Faced
- E-Mail Answers
Answer Posted / satheesh
to prevent zero sequence current flow in upstream side.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
What do you understand by avr?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
what is meaning of sympathetic tripping with respect to relays and give the values for current carrying capacities for copper and aluminium cables from 16sq mm to 500sq mm
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
State the other types of Air Conditioners?
What is the automatic voltage regulator with servomotor?
why are u join ntpc
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
Batteries. What is the difference between Lead and Nickel batteries ?
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
what is RNG in the DG synchronizing by PLC?
When and where resistance earthing is used ? How to calculate the time constant for earth fault
How we can defined theecopper cable size if we know the aluminium cable size?
