Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between radar and ultrasonic level
transmitter? Which method is best and more accurate?
- 8 Answers
- 45988 Views
- I also Faced
- E-Mail Answers
Answer Posted / basheer ali
Radar uses microwaves to find the target parameters.
Ultrasonic uses sound waves to find the target.
Radar is best suited for the targets in air, on ground.
Ultrasonic transmitter is best suited for under water
targets.both uses the same principle ( i.e transmitting
signals and receiving the echos).sonar transmitter has more
noise compared to radar. radar find more applications.
| Is This Answer Correct ? | 12 Yes | 6 No |
Post New Answer View All Answers
how to commission furnace ( water heater)
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
Draw block digram for well head from well to shipping pump?
Give 2 application of quartz crystal used for process parameter measurement.
Reason for capillary type dp level transmitter fluctuation
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
What is the procedure of calibration of Load cell?
what are the steps I have to deal with?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Questions on flow meters,few questions on HART protocol,
how works encoder in plc
Which are all the commonly used Bordon tubes in the pressure gauges. Do any one use ASTM A 312 tubes for this purpose?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
