Interested to Buy Any Domain ? << Click Here >> for more details...
How loading get increased in generator not the speed, while
we increasing steam to turbine.
- 2 Answers
- 4675 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
When the gen is connected to grid ,speed is decided by the
grid frequency.When you increase steam ,the power input to
prime mover is increased and this will be evacuated by grid
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
What is the purpose of stablization resistor in high impedance bus bar protection
What is the universal motor?
What is the necessary and sufficient condition for stability.
concept of busbar and load dispatching..?
what is destructive and non-destructive testing of welding
The height to which the liquid in a tank to be maintained for a certain constant velocity?
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
from which formula we select a capacitor rating?
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
What is transformation ratio what it describes?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
