Suppose there are two cylinders / vessels.In one cylinder
the pressure is 1.5 bar & in other 0.5 bar.If both cylinder
are connected internally through valve connection, what
will be the final pressure in both?
- 19 Answers
- 21306 Views
- BARC, Bhel, HPCL, I also Faced
- E-Mail Answers
Answer Posted / lokwadermmm jntucep
hallow plz give d volumes of cylinders
by taking same volume
p1v1=p2v2
den easyyyyyyyyyyyyyyyy
p1=p2=1
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In order to increase efficiency and reduce co emissions and other emissions, clear coal technologies are receiving major attention. What are these ?
explain about where should we use deep groove ball bearings,angular contact ball bearings,spherical roller bearings,taper roller bearings,cylindrical roller bearings and thrust bearings
Name the machines you know?
What can be reasons for a metal gas-kit to leak?
what is the trignometry of lifting tools using the wire rope ? any formula for trignometry ?
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
What do you treat in high alkalinity of boiler water?
what is the pattern of written test for the post of trainee mechanical engg.
What are different types of gate valves?
What is meant by effectiveness?
i am studying in bechanical engineering in M,S,University at Baroda.i and my friends want to take one month industrial trainning in mechanical engineering company.pleas send some company's name and procedure.
Give the safety precaution when working in a high place.
Out of constant pressure and constant volume lines on ts diagram which line has higher slope ? And whether slope is constant or variable ?
I heard that the acetylene cylinder pressure can't be brought down below bar while using for welding activity. Is it true. . If so pl explain why
What is the purpose of stern tube?
