Interested to Buy Any Domain ? << Click Here >> for more details...
why our power production in multiple of 11, in strictlly
asking why our o/p voltage of alternators is 11kv only and
whynot graterthan 15 and016KV?
- 4 Answers
- 6202 Views
- I also Faced
- E-Mail Answers
Answer Posted / naveenreddy
cause in power system we are using sinusoidal wave forms,so
the form factor of the sin wave form is 1.11,that is why we
are using multiples of 11...............
if we go beyond 15 or 16 we have to face so
many problums like insulation damages,in sufficient cooling
e.t.c
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
why ct ,cvt should be stored in a vertical position?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
How to connect the chemical earthing and complete process tell me plz
Please brief what is sinewave
What is zero of the system?
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
