Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of choke on tube light fitting
- 37 Answers
- 82312 Views
- Bhel, Dharma, HSBC, TCS, I also Faced
- E-Mail Answers
Answer Posted / madhu
when tubelight is on , due to choke voltage is increased to
1000 v and the gas in the tube light is ionised at this high
voltage . to ionise the gas in the tube light we use choke
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
What is “pu” in electrical engineering?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformer
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
why we need to us lenz's law for synchornous motor
How can we checked Killo Watts of Motor & Alternator?
trasnfarmaer core make
What is current divider rule (cdr)?
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
An automatic water heater is an example of which type of control system?
How much of the total hydro power potential has been exploited so far in india?
What are the protections for safe running of electric generator?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
