Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of impulse line in AFBC boiler , WHY WE
CONNECT IMPULSE LINE TO TRANSMITTER , DRFT GAUGE ETC ????????
- 6 Answers
- 15565 Views
- Jindal, Reliance, I also Faced
- E-Mail Answers
Answer Posted / ashwini kumar
as the impulse line are connected to that pot through that a
cold
water is poured . taken in line when steam comes
it gets condenses in that pot itself so sensor will not be
affected
hence
the use of impulse line in AFBC boiler , WHY WE
CONNECT IMPULSE LINE TO TRANSMITTER , DRFT GAUGE ETC are
done
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
how to work MIL contol valve posistioner ?
What is instrumentation technologists and mechanics?
Isometric drawings are generated during _________________ phase of a project
why we are using drum level control valve air to close?
give eg of how I/P is used in control loops
Which type of pressure can be measured by these elements?
What is hp & mp seperator .& what is its working principle ?
Full form of KKS when use DCS.
why we are not using the turbine flow meter in the steam service?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
how to calibrate Necleuonic level transmitter.?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
