Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 18341 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / kmahipalsingh@gmail.com
This cycle is based on brayton cycle which work on two pressure one is max & second is minimum after passing through turbine pressure drop from max to min
now its outlet which is steam or steam + water.now we condence this fluid at min pressure beacause if it is not done then it is difficult to compress(4 increasing press from min to max) steam+water by compressor & if turbine outlet is steam then whole the energy to compress steam eaqual to turbine outlet work(ideally) so ultimately loss.
so it is done.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
What is control system?
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
-How do you select cable size for a given load at a given distance from source of supply. How do you find voltage drop.
is it value of power factor is more than unit. whats effects in the source supply
how to size H.T & L.T Panel ?
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
What is Harmonics how it is produced and what is the method to control the same
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
Which type of transformer is used for lighting loads?
How to check the LM324 Ic
how to calculate
why single CT used in DOL starter power circuit?
