Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / m.venkatesh
hi! inrush current is initial current taken by an inductive
load when switch it on to supply
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
why Lightening Arrester Probe sharp at Top of telecom tower.
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
How to convert a two phase power into a three phase power in induction machine?
how is control wiring coding is done in a CRP panel ?
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
