Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ch subhash kumar
Bucholz relay can be tested in two ways
1. By shorting the terminals which is located in the
teriminal box of bucholz relay
2. This is real test to do this test you have to isolate
bucloz by closing the valve which is connected from main
tank to conservator tank there are two valves one is
entering to bulcoz relay and another is leaving from bulocz
relay these two valves to be closed and then there will be
a drain valve in bulcoz the bulcoz relay from there you
have to drain the oil then the float will come down it will
be activated.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What is the differentional relay...what is the work of this in power Tx. how it is works..
What is the cut-off rate?
ASTM D 3455 - Standard Test Methods for Compatibility of Construction Material with Electrical Insulating Oil of Petroleum Origin has been used for Testing Transformer Oils with a product placed in it. Aged Control Oil has a Power Factor of 0.032% at 100°C. Aged Oil with a Test component has a Power Factor of 0.093% at 100°. Is this increase acceptable? If not why? How much increase is acceptable?
percetans
how to define tell me about self
what is x'mer ,isolation x'mer & yltra-isolation x'mer?????
which stabilizer is better ? AVR, Servo Stabilizer, Static stabilizer etc & why explain it
what are the differant std sizes of cable trenches?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
why three phase capacitor takes unbalanced current in capacitor bank?
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
