Interested to Buy Any Domain ? << Click Here >> for more details...
in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
- 11 Answers
- 18067 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / ramniwas gahlot
In thermal power plant stream already available in hot
water so to get high pressure water must be first cool.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is a DC series motor?
all details of DG UPS HVAC
state basic meaning of 'INDUSTIAL AUTOMATION'?
How do you select the pickup value of the relay?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
what is the transformer turn ratio formula and give some examples?
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
what will happen if frequency is below 50 hz?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
What is servo motor? what is its purpose?
Write down the name of 2 lady Bir Pratin of Bangladesh
How to Calculate the Fault Level of Electrical Installation
What is the feedback in the control system?
What happened when capacitor connect series in ac circuit?
