in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"
Answer Posted / k.vinay kumar
steam flows from high presure area to low presure
area......
as presure is directly proportional to heat, so to create
high presure boilling is required and to create low presure
cooling is required.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
What are the characteristics of negative feedback?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What do you mean by an instrument transformer?
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
11000volt DG set carnt kaise banvay
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
In siemens PLC, why do we want to move the data ?
How to design pavement quality concrete by using C.R.C.P Method
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
how the aircraft outer body and inner body is separated ?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
why and how voltage sharing in transformer, during magnetic balance test ?